Micro SCT Spur & Pinion or Rear Differential
Hey guys new to the forum and Losi as well
So I bought a couple of 7.4 V lipos to run in my Micro SCT. I did not make any changes to the spur or pinion gears ( I know I'm a dummy I couldn't help myself then again I did buy this to tinker around and rebuild stuff) . After about 5-6 minutes it got pretty warm and just crapped out. I took it apart it looks like the spur/pinion are ok but sounds like the rear differential is where the damage is. My question is can the rear differential be rebuilt or do I just replace with the whole assembled unit. Also if I replace the spur with a smaller aluminium gear will this enable me to run Lipo without melting or stripping.
Thanks in adavance for your opinions and or help,