Desert Truck rear toe-in

[desert_trouble]

Hey Guys,
I'm fairly new to the Losi world, I got myself a Desert Truck about a month ago and I have gradually been adjusting setup on it so it handles how I want.
My problem is I want to adjust rear toe-in but I cant work out how to.
Any help much appreciated thanks

[Todd Hodge]

The rear toe in is fixed on the rear pivot to 3 degrees per side.

You can add 1 degree per side with the 1 degree hubs below. This will give you a total of 4 degrees of toe in.

LOSA9807-1 degree hubs (http://www.losi.com/Products/Features.aspx?ProdId=LOSA9807)

Or you can add 2 degrees per side with our 2 degree hubs. This will give you a total of 5 degress of toe in.
LOSA9808- 2 degree hubs (http://www.losi.com/Products/Features.aspx?ProdId=LOSA9808)

[desert_trouble]

Thanks for the info Todd,
I knew it was fixed on the pivot but the manual reads as being adjustable on the hub, so I take that means adjustable by getting other hubs.
But it doesn't help really because I want to decrease toe-in to 0 degree's.
Any Idea how I can do that?
Thanks

[Matt Sunderlage]

I'm pretty sure you're stuck a 3 degrees there....

[desert_trouble]

Thanks Matt,
I think I'm going to make my own from aluminium.
Cheers

[snoking]

Thanks for the info Todd,
I knew it was fixed on the pivot but the manual reads as being adjustable on the hub, so I take that means adjustable by getting other hubs.
But it doesn't help really because I want to decrease toe-in to 0 degree's.
Any Idea how I can do that?
Thanks

You can mount the optional hubs on the opposite sides and run the upper link to the other side of the arms. So you can remove 1 or 2 degrees depend on which optional hub you use. I removed 2 degrees, but did not notice much difference on our paved oval.

Chris