LST/Aftershock Driveshaft Connection Issue

[tynash]

Ok, so I am new to this and am trying to figure this stuff out as I come across it. I replaced my servos with new Futaba's last week or so and now my the driveshaft is not connecting properly. Please see the picture below. Any ideas how I get it to connect properly? This is the linkage connecting the front drive to the tranny. Thanks for all your assistance.


http://i32.photobucket.com/albums/d24/tynash/Losipic.jpg

[tynash]

I am sure there is away to move the drive shaft up a little but for the life of me I cannot figure out how.

[eurofocus]

There isn't a way from what I can see. If the diff is sitting properly, i'd say the chassis is bent. The drive shaft looks to be out only 1/4" but that's definitely not good. Double check the chassis isn't bent and that the diffs aren't loose.

[axial28rr]

-check your engine brace if its cracked get this http://www.horizonhobby.com/Products/Default.aspx?ProdID=DYN7214B
- you can also move the cupler up so it can reach the drive shaft
-also check if your diffs have moved back on you. check by your rear bumber to see if the screws that hold your pins in back out

AX