Brand new Ten-T whitout Steering

[burn3d]

Ok i bought my Ten-T last week and i binded it, it was working fine but now the steering is not working anymore, i can turn maybe 20% left and if i go right it go straight .. any idea? its a brand new 1 ...

[john mfkn ross]

ether your servo is striped or you need to set the travel in you transponder

[burn3d]

The travel is all 100% , is it right? ( sorry im new to Rc ) And if the servo uis stripped, what can i do ??

[deadralive1]

Pull your servo arm from the top of the steering servo and check your adapter.
You may have to pry it from the servo arm or servo itself and see if it is stripped (mine came with 4 extra in the box).
If that is it there's the problem, if not with the arm off, check that the servo is center with the radio on, without the arm on try to turn it and check for the throw.
Hope it helps...

[john mfkn ross]

ok try this unplug your steerind servo from the receiver and plug the throttle into the steering and see if it doz the same thing if so the problem is the set up in your transponder! re bind it:)

[Lapper]

While the servo arm is off you might want to turn the wheels and check the throw/tightness of the steering. Make sure all screws are in place and none backed out or broken parts. Sometimes rocks will sit on the chassis in the middle of the steering components not allowing them to turn.

[burn3d]

ok i removed the arm , but now the servo is not working anymore, its not turning anymore.. any idea of whats going on ?

[TripleC4]

did you hit anything hard like wall kerb the original servo are plastic and if you hit something at the right angle hard enough it will strip gears. better off now replacing with metal gear unit.

[deadralive1]

If all your radio gear is plugged I correctly, battery charged and secure ,well, its the servo itself.
Mine isn't out yet but I will go to metal gear, digital as soon as it does...

[burn3d]

ok i didnt hit anything, but its not working anymore,m i verified all connection, everything is allright, i think i will take it to the hobby store where i bought it and maybe replace with metal gear and stuff .. probably the better thing to do right now... Thanks everybody for your help, very appreciated!

[atye]

had same problem servo save loosen up put a lil treadlock opn problem solved