Ten t general help.

[Cure]

How do you get the carb off the engin. And is it just my set up or is the idle screw at a akward angle? Lol

[thelbz]

mines at a awkward angle but you can adjust it fine with a 1/8 precision screwdriver.

[raidersfan]

adjust all u want...i turned the idle screw so far i think the screw is gonna fall out...idle wont drop

[Timmyp8823]

Sounds like a linkage problem to me. Like the slide isn't even resting on the screw at idle.

[smithy]

I had the same problem every time brakes applied engine stalled. The slide was not on the idle stop and the linkage moved back every time the brakes were applied causing engine to stall. Adjusted linkage so that slide was on the stop with a bit of spring tension , problem solved.
Ron

[StrangeRanger]

How do you get the carb off the engin. And is it just my set up or is the idle screw at a akward angle? Lol

Look around the base of the carb and you'll find a pinch bolt that basically squeezes the carb into place. From this pic it looks like access is from the inboard side of the motor:

Ok, never mind, I can't link to a pic. But look at the base of the carb and you'll see it.
j

[Cure]

I can lossen the pinch bolt, carb will rotate. When I pull it won't come out .