LST will not shift

[evenz3r0]

I changed out the LST tranny for a Aftershock.
Then I added the high speed cov.
Put new 2 speed clutch an still nothing. factory settings is 5 I'm all the way out to 7 turn
The engine is well tuned.
Any ideas would help.
Thanks

[askewzero]

Make sure the 2-speed clutch is turning freely in the bell. I had it keep getting stuck on mine til I got a new bell, which effectively makes it stay in high gear. Also if you have the screws out too far it will be in 2nd gear almost immediately as well. Of course both of these ideas only apply if it is staying in high gear, if you are sure it's in low gear and not shifting up, that's different.

[evenz3r0]

The screws an bolts did look like there out just a little too far- .But it come with the metal spur an clutch bell set.

[evenz3r0]

No that was not the problem.Screws an bolts are fine.

[axial28rr]

make sure there is no oil or no lub around the slipper also when you adjust the 2 speed make sure you rollers are rideing on the pilot shaft if its not you might have grided done the pilot shaft when you adjust the 2 speed the side that it is shifting into lossen a little more then the oppsite side

[evenz3r0]

There all new parts
no oil no damage-an its stuck on the low end.Ton of power - wheelies etc- but no shift.

[evenz3r0]

you like that engine axial? I was looking into them- have any problen breaking pin-type that seem to be everywhere- tire hubs -etc

[axial28rr]

ya i doo it really good all round engine and good for racing heres a vid http://www.youtube.com/watch?v=PnCXPVx7JBg i was at a track ruunning rich i was on my first gallon still but know its just nuts